How to Make a Card Flip Chute
Equipment:
|
|
Method:
1. Make two rectangular holes in the carton as shown in the picture.
2. With your other milk carton, cut off two sides. What shape are the sides?
2. With your other milk carton, cut off two sides. What shape are the sides?
3. Cut one rectangle about 5 cm shorter than the other.
4. Fold the long rectangle at each end (about 2 cm down)
5. Put this piece of carton into the top hole and stick the fold to the outside to the top of the top rectangular hole.
6. Then stick the other fold on the outside of the bottom rectangular hole, but this time on the bottom.
5. Put this piece of carton into the top hole and stick the fold to the outside to the top of the top rectangular hole.
6. Then stick the other fold on the outside of the bottom rectangular hole, but this time on the bottom.
7. Fold the short rectangle at each end (about 2 cm down)
8. Put this piece of carton into the top hole, but this time stick the fold to the outside of the bottom of the rectangular hole.
8. Put this piece of carton into the top hole, but this time stick the fold to the outside of the bottom of the rectangular hole.
9. Then stick the other fold on the outside of the top of the rectangular hole.
*So the long rectangle is stuck to the edge of the rectangle that is closest the to top and the bottom of the carton, and the short rectangle is stuck to the inside sides of the rectangle.
*So the long rectangle is stuck to the edge of the rectangle that is closest the to top and the bottom of the carton, and the short rectangle is stuck to the inside sides of the rectangle.
10. Put a flip card (a card with a question on the front and an answer on the back) into the top slot and it should flip over and come out the bottom slot!